Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Hybrid Repeater and device activation

  1. #1

    Hybrid Repeater and device activation

    Do RF devices "marry" to a specific repeater during activation? I am curious if a device will always look for the repeater it was activated against, even if a second repeater is added to the system later that is closer in proximity. (Marry a dimmer to repeater A, weeks later come back and add repeater B at a closer location, will dimmer still want to connect to repeater A).

    My reason for asking is that I saw this behavior in the early stages of RA2. I had a job where I added all RF devices to the Main Repeater before sending out to field. Aux repeater added onsite, all devices still tried connecting to main repeater. Had to de-activate and re-activate everything with Aux repeater on the system.

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    251
    Hi toteshouse, if the repeaters are on the same link then they will both be on the same frequency and would communicate with the closest repeater. If the Hybrid Repeaters are on different links, then it would act similar to a 2 Main Repeater system. The repeaters will have different frequencies and a device will only communicate with the repeater that it was activated to, even if there is a closer repeater on a different frequency.

  3. #3
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,250
    I was told tabletop keypads are an exception, that they would communicate with any repeater. Haven't tested this.

    I'm guessing Pico's, are also RF link dependent.
    LED, Incorporated
    Raleigh, NC 27614

  4. #4
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    251
    All RF devices are link specific. The RF devices can only communicate on the frequency they are activated on, if there is more than 1 RF link then the devices will locked into that link.

Similar Threads

  1. Device fell out of activation
    By MitchE in forum Troubleshooting - RA2
    Replies: 0
    Last Post: 08-25-2017, 12:13 PM
  2. Activation
    By Mojtaba in forum Troubleshooting - RA2
    Replies: 11
    Last Post: 08-03-2017, 09:11 AM
  3. New Feature request add Hybrid to "Edit Device"
    By paulhanks in forum Programming - RA2
    Replies: 4
    Last Post: 09-18-2014, 02:18 PM
  4. Replies: 1
    Last Post: 09-15-2014, 04:02 PM
  5. QSGRJ-6PBA breaks device activation
    By sergiobaiao in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 10-31-2013, 08:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •