Ok, Im sure im not the only one to think about this....
I would like to "Rig" a way to put the wireless dongle instead of at the shade side, but located in closet where power supplies are located. What is the voltage of the Dongle? i "ASSume" that its the same as the drive. So, is it possible using standard qs cable to...
1. connect power to the shade using pins 1 and 2.
2. connect a wire from the wireless harness for communication to pins 3 and 4 of the main molex connector.
3. back at power supply side, attach both power to dongle, then pins 3 and 4 from wire run to the dongle?
Does this make sense to anyone?
If so, i could have all my wireless dongles in one room. this would mitigate wireless issues for the shades (it does happen). It wouldnt limit the number of repeaters as i would still need that for the controls of the house. But it would take away issues such as metal pockets that can block wireless.....