Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Single Press Off and Hold for Dim down

  1. #1
    Junior Member
    Join Date
    Feb 2016
    Posts
    1

    Single Press Off and Hold for Dim down

    Hi Guys and Girls
    Was wondering if anyone can help me with this button model please ?,
    I have been requested by a client that a single press turns off a room,( thats easy ), but also wants the same button if held down to do a master lower dim.
    These are easy when done individually, but i cannot see how to do this on the same button, any ideas would be gratefully received. I have a project where it needs to be rolled out to about 85 keypads.

    Thanks
    Richard B

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,203
    On the programming screen near the LED logic drop down there is a check box called cycle dim. When you press and hold the button the LED will flash and dim the loads assigned to that button. If you release and press again the lights will raise. If you release and the LED stops flashing (1-2 sec) the button is back in toggle mode. You can specify the initial direction (raise or lower) in Project Settings/Programming.
    LED, Incorporated
    Raleigh, NC 27614

Similar Threads

  1. Press, Hold, Release Event
    By franlog in forum 3rd-party Integration - HWQS
    Replies: 1
    Last Post: 09-22-2016, 03:04 PM
  2. currently 1 hour and 28 minutes on hold
    By sdaven in forum General Discussion - HWQS
    Replies: 0
    Last Post: 03-17-2016, 08:42 PM
  3. Cycle Dim Hold time
    By totesthouse in forum Programming - HWQS
    Replies: 1
    Last Post: 06-19-2015, 10:48 AM
  4. Press On/Press Off Macro
    By TurnipTruck in forum Programming - HWQS
    Replies: 5
    Last Post: 01-18-2014, 11:54 AM
  5. Press and Hold-Add a keypad or repeater Beep?
    By thefish in forum Programming - HWQS
    Replies: 4
    Last Post: 11-08-2013, 12:14 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •