Originally Posted by
randyc
What is the model number of the dimmer you have?
The dimmer must be at either end of the circuit. It can not be in the middle. If you have an electronic dimmer (like Maestro) you will need to change the other 2 locations to Maestro companion dimmers. If you have a dimmer with a neutral connection, it must be at the end where the wire goes up to the light.
I would also check the trim setting.
Dimming Range Adjustment
Goal: To set the dimmer to reach the lowest stable light level that can be achieved with your light bulb(s).
1. Turn on dimmer switch 1 (shown below). Move down slider 2 to lowest light level.
2. Turn down (counter-clockwise) adjustment dial 3 to lowest possible dimming level where light output for
all bulbs is stable and does not flicker or flash.
Note: If dial stops, do not continue to turn.
3. Turn off dimmer switch 1 , then back on. Verify that all bulbs turn on.
4. If all bulbs do not turn on, turn up (clockwise) adjustment dial 3 slightly and repeat step 3.
5. Once all bulbs turn on reliably, install wallplate.