Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Cree LED Low End Trim

  1. #1
    Junior Member
    Join Date
    Jan 2018
    Posts
    6

    Cree LED Low End Trim

    I have Cree LED bulbs, and a scene setup with RRD-6NA dimmers, the scene sets the dim level to 1%, of course not all of the banks of lights come on.

    However, if I turn them to full on and then to 1% it works fine (with no flicker).

    I’ve also repeated the test with 5%, and the same effect.

    Repeating with 10% works, however, it is significantly brighter than 1% or 5%.

    Any suggestion?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    I don't know what bulb you are using but the LED Report Card tool only lists 1 Cree fixture that will go to 1%. There are a couple that go to 5%. Lutron probably lists higher low ends to avoid the issues you are describing.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Jan 2018
    Posts
    6
    SRDL6 and SRDL4 which I can’t find the report card for, but they work fine all the way down to 1%

    The circuit I have a problem with though has 2 SRDL6 bulbs, and two A19 bulbs (http://www.lutron.com/en-US/Resource...%20REV%20B.pdf) it looks like the A19 only support 9% so I guess that’s where my issue is, probably makes sense to trim all the ones in that floor at 9% until I can potentially replace that fixture with a downlight, although I wish there was a report card for the downlights.

    Is there a better A19 bulb to use?

  4. #4
    Senior Member
    Join Date
    Jul 2015
    Posts
    214
    You didn't mention it, so I'm just confirming. Did you set the low end trim properly on each of the individual RRD-6NA dimmers?

Similar Threads

  1. Replies: 3
    Last Post: 05-20-2018, 09:23 PM
  2. Low/high end trim not honoured by iOS app/homekit
    By tristank in forum Troubleshooting - CAS
    Replies: 4
    Last Post: 10-29-2017, 12:56 PM
  3. Trouble with 6NA Dimmer and Cree CR6
    By dinom in forum Troubleshooting - RA2
    Replies: 8
    Last Post: 11-10-2015, 07:21 AM
  4. Newer Cree lamp and RRD 10 ND
    By digit1 in forum Performance Issues - LED
    Replies: 4
    Last Post: 11-02-2015, 08:16 AM
  5. Cree LED Flickering
    By xdarkzerox in forum Performance Issues - LED
    Replies: 3
    Last Post: 06-02-2014, 11:44 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •