Hi.
I am trying to control a skylight motor.It is set for pulsed CCO.The relay is set for pulsed.I can control on 2 Keypad buttons no problem.Open,close but i cannot make it stop.It just reverses course.Also on a sequence i can control from 1 button.I am trying to have it operate as Open,stop,close.Which i set up in the sequence but i cannot make it stop in a position it just reverses.The relay says for pulsed. Press switch once and release. To stop motor, press opposite command.
I spent 4 hours on this today.Any ideas?
Thanks Steven.