Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Open stop start for motor control

  1. #1
    Junior Member
    Join Date
    Aug 2016
    Posts
    3

    Open stop start for motor control

    Hi.

    I am trying to control a skylight motor.It is set for pulsed CCO.The relay is set for pulsed.I can control on 2 Keypad buttons no problem.Open,close but i cannot make it stop.It just reverses course.Also on a sequence i can control from 1 button.I am trying to have it operate as Open,stop,close.Which i set up in the sequence but i cannot make it stop in a position it just reverses.The relay says for pulsed. Press switch once and release. To stop motor, press opposite command.
    I spent 4 hours on this today.Any ideas?
    Thanks Steven.

  2. #2
    Senior Member
    Join Date
    May 2013
    Posts
    420
    Hello stelo66,
    I would disconnect the wires from the HWQS interface and short them manually. If the motor does not stop as stated then contact the manufacturer for the skylight.

Similar Threads

  1. Can 4T10 control fan motor?
    By Stairway_to_heaven in forum General Discussion - HWQS
    Replies: 1
    Last Post: 09-22-2017, 04:33 PM
  2. Motor Differences
    By DavidGroves in forum Design Assistance - Shades
    Replies: 1
    Last Post: 03-01-2017, 10:18 AM
  3. Open Stop Close Stop with Maintained CCO shades
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 04-01-2015, 12:38 PM
  4. Open Stop Close Stop with pulsed CCO shades.
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 11-05-2014, 11:04 AM
  5. Replies: 0
    Last Post: 07-11-2014, 02:36 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •