Pico remote - clear the preset button?

[themartb]

Hi,

I'm wondering if it's possible to clear the preset button on a PJ2-3BRL ... actually erase any setting at all so that when pressed, it does nothing?
Would the in-wall dimmers it controls need any adjustments perhaps? I ask because I tried removing the Pico from the system and re-adding it, but the preset button retained it's setting value (still works).

I guess if there's a procedure to reset things back to factory default that could work, but I did not see any references to that in the docs.

[Sawdust]

The button will always do something, even a factory reset would just reset it back to 50%. If it is a must that it do nothing, best bet would be to take it apart and remove the little connection between the button and circuit board.

[SDR-Mike]

You can always replace it with 2 button- raise/lower version of the Pico. PJ2-2BRL-Gxx

[themartb]

Sounds like I'm going to just live with it doing the 50% thing ... Thanks for the replies guys, appreciated.

[davisadm]

If you are using the Smart Bridge or Smart Bridge Pro, just uncheck all lights for the favorites button.

[davisadm]

Oops! I was thinking of the scene Picos. You can't disable the favorites button.

If you are using the Smart Bridge or Smart Bridge Pro, just uncheck all lights for the favorites button.

- - - Updated - - -

Oops! I was thinking of the scene Picos. You can't disable the favorites button.

If you are using the Smart Bridge or Smart Bridge Pro, just uncheck all lights for the favorites button.