Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: AFCI Issues

  1. #1
    Junior Member
    Join Date
    Dec 2017
    Posts
    1

    AFCI Issues

    I have a 4A mod that has been fine for months, now constantly trips. The circuit holds just fine with a regular QO breaker. And holds with the AFCI until any of the loads is turned on. Then instant trip.
    Any suggestions?

    Thanks

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Arc fault breakers are more sensitive than standard breakers and test for several errors. The breaker should indicate the reason for the trip. This could be a blink code or a combination of LEDs.

    I would disconnect the loads from the 4A, then connect 1 at a time to see if you can isolate the issue.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. 2 Different Issues
    By spartacus1882 in forum Troubleshooting - CAS
    Replies: 1
    Last Post: 12-20-2016, 04:46 PM
  2. Diva and Feit and AFCI
    By MitchE in forum Compatibility - LED
    Replies: 2
    Last Post: 05-17-2016, 04:26 PM
  3. Is there any known issue with 6NA and AFCI (arc fault) breakers?
    By ultravelocity in forum Troubleshooting - RA2
    Replies: 2
    Last Post: 12-30-2015, 12:20 PM
  4. 8.0.0 issues ?
    By mehuneau in forum General Discussion - HWQS
    Replies: 2
    Last Post: 11-28-2014, 04:10 PM
  5. LED Issues
    By brewcrew0 in forum Troubleshooting - RA2
    Replies: 7
    Last Post: 05-27-2014, 12:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •