Pico Remote - How to mount to look like a normal single gang switch but surface mount

[Drconner]

Hello! I have a few areas where I would like to surface mount a Pico remote and make it look like it is a regular switch (trimmed out with wall plate) but only be surface mounted so that I don't have to cut unnecessary holes in the walls.

Anyone see any products that do this? I've tried searching but I'm not having much luck.

Thanks!

[SDR-Mike]

Check here: https://forums.lutron.com/showthread...tely-flush-yes!

[wkearney99]

I've used those clips with the Lutron Claro faceplates, along with some 3M Command picture hanging strips. It's almost totally indistinguishable from an actual in-wall box.

This 50-pack was a pretty good deal at the time:
https://www.amazon.com/gp/product/B00GFG4ATA/

[Drconner]

Thanks for the info! I'll give that a try.

-dc