Illumination to QS 12.1 convert - missing dimmers

[totesthouse]

Converted 1.65 Illumination project using the online tool and then upgraded the result to QS 12.1

All of my switches, and dimmers (HWD-6D) show in the QS program under CONTROLS. However, when I change a processor link to Q96/H48, none of the devices show up as assignable to that link.

How do I go about adding these devices to the link? I don't see any options to add an actual H-48 board.

[digit1]

Converted 1.65 Illumination project using the online tool and then upgraded the result to QS 12.1

All of my switches, and dimmers (HWD-6D) show in the QS program under CONTROLS. However, when I change a processor link to Q96/H48, none of the devices show up as assignable to that link.

How do I go about adding these devices to the link? I don't see any options to add an actual H-48 board.

Is it too late to assign all the devices in the 1st converted project and then upgrade to 12.1?

[totesthouse]

I put in a bit of time adding all the programming to the keypads in 12.1. Are there other options or did I miss a step somewhere?

[totesthouse]

Looks like an LV-17 panel needs to be added in equipment. This has the H48 in it.

[Blair S.]

Hello toteshouse,
Thank you for your post.
You must first assign the H48 devices to the H48 board. Then the H48 board gets assigned to the link. Please refer to the application notes on the HW Illum to HWQS upgrade topic for more details.