When assigning a load to a module I can not see the actual load (watts). One has to print out a load schedule to see the loads an check them off as you go. I am I missing something?
When assigning a load to a module I can not see the actual load (watts). One has to print out a load schedule to see the loads an check them off as you go. I am I missing something?
On the design->equipment screen, where you are assigning the loads to the power panels, there will be a link on the top right of that window that says "customize columns". Please click on the link and check the box for "Wattage". It will then display the wattage for every RPM output.
My problem is not with the wattage being seen at the RPM it is with the assignment box, you can not see the wattage at the assignment box this leads to a lot of assigning and un assigning.
Thank you for further clarifying the application and feedback on having the wattages on the assignment window.