Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: MS-OPS2 manually turns on and off LED light, but doesn't allow programming

  1. #1
    Junior Member
    Join Date
    Oct 2017
    Posts
    1

    MS-OPS2 manually turns on and off LED light, but doesn't allow programming

    I have checked grounding (green and bare wired together, and wired to copper ground wire in gang box). Turn on breaker. 3 flashes, wait 2 minutes, depress light button, programming flashes do no flash. Depress motion sensor button, programming flashes do not flash. Press both buttons to reset to default settings, no flashes. Light button will turn off and on light manually.

  2. #2
    Authorized Lutron Contributor
    Join Date
    Dec 2015
    Posts
    185
    Hello mbeckham. We would suggest emailing out tech support team at support@lutron.com for assistance with this application.

Similar Threads

  1. Manually triggering smart away
    By ZipZap in forum General Discussion - CAS
    Replies: 3
    Last Post: 12-15-2016, 09:46 PM
  2. Replies: 7
    Last Post: 11-16-2016, 06:31 PM
  3. MA-LFQHW light swtich turns on fan on full brightness
    By teepee1232 in forum General Discussion - Controls
    Replies: 2
    Last Post: 10-09-2016, 10:14 AM
  4. Replies: 1
    Last Post: 09-01-2015, 12:24 AM
  5. Controlling dimmer's dimmed position manually
    By jchitrady in forum General Discussion - RA2
    Replies: 3
    Last Post: 08-26-2014, 03:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •