Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: "dummy" keypads for HQW-NB-NONE

  1. #1
    Senior Member
    Join Date
    Oct 2013
    Posts
    114

    "dummy" keypads for HQW-NB-NONE

    For HomeWorks/Illumination, when you ordered a ST(R)-NB-NONE, you use to get those "dummy" keypads which had flat writable "buttons". Then when your clients finally decided on the actual engraving, you would order the engraved button kit and swap it out.

    It turns out that when you order the HWQ-NB-NONE, these "dummy" keypads are no longer included. An exchange with customer service did not get me anywhere. I finally found an old set from a job that I did years ago and it turns out that the "dummy" keypads from a STR-NB-NONE actually fit (and work) on a HWQ-NB-NONE.

    Does anyone happen to know if these "dummy" keypads can be ordered separately and if so, do you have a part number?

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    403
    These button kits were never intended to be sold separately. We also received feedback from our dealers stating that they did not like using these 'temporary keypad inserts' and felt as though they were wasteful. As a result, we no longer offer this component to be sold with the HQW-NB-NONE.

  3. #3
    Senior Member
    Join Date
    Oct 2013
    Posts
    114
    that's really too bad; I liked and used them quite a bit…any chance I can get around 20 for my next install?

Similar Threads

  1. HWI phantom buttons and HWQS "Virtual" keypads
    By LightBrigade in forum Programming - HWQS
    Replies: 12
    Last Post: 05-28-2014, 12:24 PM
  2. HVAC Controller "smarts"
    By ekimla in forum Programming - HWQS
    Replies: 4
    Last Post: 03-10-2014, 01:25 PM
  3. HQWS and "Auto" device feature
    By thefish in forum General Discussion - HWQS
    Replies: 3
    Last Post: 11-02-2013, 03:36 PM
  4. "Unaffected" invisible in Level Editor
    By LightBrigade in forum Programming - HWQS
    Replies: 1
    Last Post: 10-15-2013, 11:25 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •