Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Single pole no longer works

  1. #1
    Junior Member
    Join Date
    Sep 2017
    Posts
    1

    Single pole no longer works

    Hi, I have a few caseta’s (caseti?) installed around my house. They all work great... except for one.

    its the one that is connected to my outdoor porch light which I rarely use. It was a three way but I converted it single pole as per the instructions. It was working great for a couple of weeks and then one day I came back to see that the lights were flickering on and off slowly (about one or half a hertz). So I turned it off and didn’t think twice about it.

    then the other day I looked at the casita switch for this light... and the series of dim green lights (when off) where now dark. Of course toggling the switch did nothing. So I tried pulling the tab that turns the thing off completely and pushed it back in. At this point, the series of green lights turned on: first the most bottom light, and then step wise up.... until the final topmost light - which did not light up. Then the green lights are all dark again and the switch doesn’t work... still.

    Any ideas? Cheers,

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    It sounds like you have dropped below the minimum load threshold. Try replacing the bulb(s).
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. MA-LFQHW Alternative for LED dual fan/light control on Single Pole wiring?
    By jjtrinva in forum General Discussion - Controls
    Replies: 1
    Last Post: 08-16-2017, 11:23 AM
  2. Solution for single-pole ceiling fan to control light/fan dimming + led?
    By jjtrinva in forum General Discussion - RA2
    Replies: 2
    Last Post: 08-03-2017, 11:17 AM
  3. Maestro Single Pole Fan/Light dimmer Power to the Fixture
    By jtaaustin in forum Troubleshooting - Controls
    Replies: 2
    Last Post: 07-06-2016, 11:43 AM
  4. Keypads and Dimmer switches no longer working
    By deyster in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 06-08-2015, 11:08 AM
  5. Can someone tell me why Israel is no longer supported in the RA2 Inclusive Software?
    By RA2-Designer-Gal in forum General Discussion - RA2
    Replies: 1
    Last Post: 05-06-2014, 12:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •