Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Empty keypad button LED stays lit

  1. #1
    Senior Member
    Join Date
    Jul 2015
    Posts
    214

    Empty keypad button LED stays lit

    I'm pretty sure I've seen posts about this issue before, but now I can't find them. I have some empty buttons on a couple of keypads (RRD-W7B), and the LEDs for these buttons are lit and won't go out. How do I get these buttons to go out? Eventually I'll get engraving done and I won't have to worry about empty buttons. But for now, I'm stuck with them. I'm running 11.5.
    Thanks

  2. #2
    Senior Member
    Join Date
    Jul 2015
    Posts
    214
    I solved this problem myself. Lutron Support suggested removing the keypads from the project, defaulting the devices, and then starting again.

    Instead, I added a zone to each of the empty buttons, transferred, then removed the programming from the buttons and transferred again. That solved the problem. The indicator LEDs on the empty buttons are now off.

    Mike

Similar Threads

  1. Hybrid Keypad initial button config vs engraved button config
    By gt3mike in forum Design Assistance - RA2
    Replies: 6
    Last Post: 05-09-2019, 12:21 PM
  2. Maestro occupancy switch turns on without any motion and stays on
    By gtakevin in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 06-16-2017, 11:41 PM
  3. Keypad button replacement kit
    By joshg in forum Design Assistance - RA2
    Replies: 3
    Last Post: 01-14-2016, 01:23 AM
  4. How to Set LED from Hold Tab of a Keypad Button
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 12-10-2014, 02:57 PM
  5. Replies: 0
    Last Post: 10-27-2014, 06:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •