Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: RRD-2ANF Compatibility with Modern Fan Company fans

  1. #1
    Junior Member
    Join Date
    Jun 2017
    Posts
    14

    RRD-2ANF Compatibility with Modern Fan Company fans

    I'm fairly certain the RRD-2ANF will work for this fan, but wanted to double check:

    https://modernfan.com/fan/plum

    It is an AC motor, and after speaking with the company that makes it, the only two requirements are that the Lutron controls provide at at least 1A to the fan, and that the RRD-2ANF adjusts speed in a "step fashion" (which I think the 2ANF does - 3 steps).

    They actually provide a basic 3-4 step "controller" that you can use if you would like (they also have more advanced RF options which I am avoiding).

    Do you think this will work?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    983
    I think you are going to have to experiment. The 2ANF requires a fan with a permanent split capacitor. These typically have a pull-chain for speed control. The fan doesn't provide much technical data.

    I would ask the manufacturer what happens if you put a toggle switch on the fan. Does the fan go to max speed? If so, there is a good chance the 2anf will work.
    LED, Incorporated
    Raleigh, NC 27614

Similar Threads

  1. ceiling fans
    By rroonnbb in forum General Discussion - RA2
    Replies: 10
    Last Post: 03-04-2019, 12:44 PM
  2. Fan control with Craftmade fans
    By zcasper in forum General Discussion - RA2
    Replies: 8
    Last Post: 02-01-2019, 11:26 AM
  3. Grafik-Eye QS and ceiling fans
    By joshg in forum Design Assistance - RA2
    Replies: 1
    Last Post: 10-31-2016, 12:15 PM
  4. Multiple Ceiling fans & RRD-2ANF
    By mike123abc in forum Design Assistance - RA2
    Replies: 9
    Last Post: 10-06-2016, 12:35 PM
  5. Replies: 4
    Last Post: 06-03-2016, 11:15 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •