Results 1 to 6 of 6

Thread: Zone intermittently Turns On By Itself-Can't be turned off

  1. #1
    Junior Member
    Join Date
    Jun 2014
    Posts
    7

    Zone intermittently Turns On By Itself-Can't be turned off

    I have a circuit that intermittently turns on by itself. The LED next to the pad is NOT lit. If I go to the HWI software it does not show it as on. I tried rebooting the processor via software and that didn't change anything. I tried an "All-OFF" button that I'd programmed into my system and that DID turn off the circuit, and now it works normally. ... Until the next time!

    Any thoughts?

  2. #2
    Super Moderator
    Join Date
    May 2013
    Posts
    295
    Hello DHKaplan,
    Thank you for your post.
    What is the load type? What is the dimming control? Perhaps they are not compatible and this is the reason for the issue.

  3. #3
    Junior Member
    Join Date
    Jun 2014
    Posts
    7
    The load is a transformer feeding a 12V cable light system. The "dimmer control" is the standard Homeworks module in the electrical panel. This has worked fine for over 10 years and is now acting up.

  4. #4
    Super Moderator
    Join Date
    May 2013
    Posts
    295
    What is the load type on the low voltage side of the transformer?

  5. #5
    Junior Member
    Join Date
    Jun 2014
    Posts
    7
    Low voltage load is 20w halogen MR16....

  6. #6
    Super Moderator
    Join Date
    May 2013
    Posts
    295
    I would swap with a known good RPM to see if the issue follows.

Similar Threads

  1. Lights flash when turned on
    By Grsthegreat in forum Troubleshooting - CAS
    Replies: 13
    Last Post: 03-01-2017, 11:17 AM
  2. Lights flash when turned on
    By Dlilly85 in forum Troubleshooting - CAS
    Replies: 1
    Last Post: 08-04-2016, 08:44 AM
  3. Caseta randomly turns on and off
    By reedm in forum Troubleshooting - CAS
    Replies: 4
    Last Post: 02-08-2016, 05:05 PM
  4. Green Scene button turns off on itself
    By Dimerize in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 01-04-2016, 07:37 PM
  5. Scene turns on after off press....
    By guskousteris in forum Troubleshooting - RA2
    Replies: 12
    Last Post: 10-21-2013, 12:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •