Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4

Thread: Backup Configuration

  1. #1
    Junior Member
    Join Date
    Mar 2017
    Posts
    15

    Backup Configuration

    I Go into Home Works Illuniation system using Home Works Illumination software 1.65 and connect with the telnet console

    I then extract the project (down arrow) and save it. it saves as an HDF file which is 256KB

    I try to open it I get the error message 3343 unrecognized data base format

    A normal project file is 2000kb

    What could be the issue, I like to backup my config before I make changes
    Pete Watters
    Home Automation Associates

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    433
    That small of a file is a corrupted file. Usually when that small it it unrepairable by Lutron.

  3. #3
    Junior Member
    Join Date
    Mar 2017
    Posts
    15
    Whe I hit the down arrow the file corruption is always the same so what could I be doing wrong. Is there some setting that could be causing this
    Pete Watters
    Home Automation Associates

  4. #4
    Senior Member
    Join Date
    Oct 2013
    Posts
    433
    You are not doing anything wrong. The file stored is not the same file running. Basically the processor stores a copy of the running file on upload. When you extract you extract the stored copy. The copy that is stored is either corrupt or getting corrupted during the extraction. This is not uncommon unfortunately especially after the illumination app was introduced the xml files corrupted easily. You can try a few things that i have had luck with in the past. Try extracting at a lower baud rate try extracting with ethernet or try extracting with Lutron extraction utility sometimes it helps and it takes several attempts

Similar Threads

  1. Grafik Eye QS Configuration
    By Joe M. in forum Programming - General Commercial
    Replies: 1
    Last Post: 11-25-2021, 02:22 AM
  2. Copy configuration from one bridge to another
    By Cherga in forum Programming - CAS
    Replies: 2
    Last Post: 11-09-2018, 08:01 PM
  3. Which System Configuration Will Work for Me?
    By nickr06 in forum Design Assistance - CAS
    Replies: 3
    Last Post: 01-21-2017, 07:21 PM
  4. Integration Configuration (ID's)
    By GLDCSTAV in forum 3rd-party Integration - RA2
    Replies: 1
    Last Post: 10-30-2016, 06:28 PM
  5. PD-6ANS flickering on a 4 way configuration
    By rmontanez in forum Troubleshooting - CAS
    Replies: 0
    Last Post: 08-08-2016, 08:01 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •