Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: LTEA4U1UKS??Hi-Lume LED driver with electrical back-box)

  1. #1
    Junior Member
    Join Date
    Dec 2016
    Posts
    5

    LTEA4U1UKS??Hi-Lume LED driver with electrical back-box)

    I am planning to install some Lutron PD-10NXD (Caseta MLV Dimmer) switches and LTEA4U1UKS (Hi-Lume 1% 2-wire) LED Drivers along with LED strip lights for a new cove. I already have a quad width (four switch) backbox in the wall, where I hope to install the LED driver and hopefully also the PD-10NXD, then use the final width for a cable draw to feed to the LED strip light.

    Is it possible to remove the Hi-Lume LED Driver's backbox that it is packaged with and install into an existing backbox?
    Would it still allow sufficient space to use the other two side for installation of the Caseta MLV dimmer and a cable pull plate?

    Any help appreciated.

    Jeff H.

  2. #2
    Administrator
    Join Date
    Dec 2015
    Posts
    185
    Hello Jeff,

    We cannot recommend removing the driver from the J-box it's mounted too, and installing it in a 4-gang wall box. The driver should have a minimum of 3" spacing all around it for heat dissipation.

Similar Threads

  1. Want to learn more about the Hi-lume A-Series LED Driver?
    By Blair S. in forum Lutron Hi-Performance LED Driver - LED
    Replies: 4
    Last Post: 10-27-2020, 07:28 AM
  2. Lutron Hi-lume A-Series 1% dimming LED driver
    By PruTodd in forum Lutron Hi-Performance LED Driver - LED
    Replies: 2
    Last Post: 03-30-2018, 04:52 PM
  3. Correct control/switch for Hi-lume A-Series driver and 1.5A G4 bulbs
    By ingan in forum Lutron Hi-Performance LED Driver - LED
    Replies: 1
    Last Post: 01-19-2016, 02:07 PM
  4. Replies: 2
    Last Post: 01-15-2016, 01:20 PM
  5. Replies: 1
    Last Post: 10-02-2013, 12:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •