LTEA4U1UKS??Hi-Lume LED driver with electrical back-box)

[haruba]

I am planning to install some Lutron PD-10NXD (Caseta MLV Dimmer) switches and LTEA4U1UKS (Hi-Lume 1% 2-wire) LED Drivers along with LED strip lights for a new cove. I already have a quad width (four switch) backbox in the wall, where I hope to install the LED driver and hopefully also the PD-10NXD, then use the final width for a cable draw to feed to the LED strip light.

Is it possible to remove the Hi-Lume LED Driver's backbox that it is packaged with and install into an existing backbox?
Would it still allow sufficient space to use the other two side for installation of the Caseta MLV dimmer and a cable pull plate?

Any help appreciated.

Jeff H.

[Jai H.]

Hello Jeff,

We cannot recommend removing the driver from the J-box it's mounted too, and installing it in a 4-gang wall box. The driver should have a minimum of 3" spacing all around it for heat dissipation.