Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Installation of MS-OPS5MH sensor for 3-way Switches

  1. #1
    Junior Member
    Join Date
    Feb 2017
    Posts
    1

    Installation of MS-OPS5MH sensor for 3-way Switches

    My laundry can be accessed from garage and from house inside. The light fixture is controlled by two switches. One locates near garage door while other one is at the entrance of laundry. I installed MS-OPS5MH with occupancy mode to replace the one near garage door. The sensor works if I keep the switch at the entrance always ON. If I switch off the light using the switch at the entrance, the sensor is not able to turn the light back on. Now, I cannot use the switch at the entrance to turn on and turn off the light manually. Does it work as designed?

  2. #2
    Administrator
    Join Date
    Dec 2015
    Posts
    185
    Hello,

    Have you re-wire the mechanical switch? If not, that should solve the issue for you. See page 9 of the following spec sheet for a wiring diagram.

    http://www.lutron.com/TechnicalDocum...ary/369488.pdf

Similar Threads

  1. Radio Ra2 HVAC installation right
    By savimagc in forum Troubleshooting - RA2
    Replies: 6
    Last Post: 10-01-2018, 06:24 PM
  2. Link Terminator installation
    By rameshkhiani in forum General Discussion - HWQS
    Replies: 1
    Last Post: 09-19-2016, 01:07 PM
  3. Installation help
    By bwietharn in forum Troubleshooting - CAS
    Replies: 5
    Last Post: 07-09-2016, 02:32 PM
  4. Two Switches / One Vacancy Sensor / Two Time Outs?
    By Mike1983 in forum General Discussion - CAS
    Replies: 1
    Last Post: 01-19-2016, 06:14 PM
  5. (mostly) Whole-house installation COMPLETE!
    By asherrick in forum General Discussion - CAS
    Replies: 13
    Last Post: 01-08-2016, 05:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •