Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4

Thread: Raise / Lower a single scene only

  1. #1
    Junior Member
    Join Date
    Apr 2016
    Posts
    17

    Raise / Lower a single scene only

    I'm having problems raising (and lowering) lights in set scenes. At the moment every circuit that is in the scene raises or lowers in proportion.
    ie in Kitchen I have six circuits: scene 3 has 3 circuits on and 3 circuits set to 0ff , if I raise light level manually all the circuits raise.
    I have set the tools/project settings/programming / raise from off, set to do not raise from off and was wondering if it was to do with the type module that the circuit is connected to as the architecture of the project dictated we used a WPM.

    Any help will be greatly appreciated

    A

  2. #2
    Junior Member
    Join Date
    Feb 2015
    Posts
    19
    Hi,
    i have the same problem, i would like to cycle dim only the lights that are on in a scene and not the ones that i've set to be off.
    Tried the project setting "do not raise from off" but the behaviour is the same.

    Is there a way to have it in this way?

    Thanks

  3. #3
    Junior Member
    Join Date
    Apr 2016
    Posts
    17
    Hi Mario
    I spoke with Support and they said it was a known issue if your using WPM's. They said they are hoping to resolve it in a forthcoming software/firmware update.

    Apparently it shouldn't affect any of the other modules though.
    Hope that helps

    Andrew

  4. #4
    Junior Member
    Join Date
    Feb 2015
    Posts
    19
    thanks for the info,
    i guess it's not just WPM's since I'm having this issue with DALI loads driven by LQSE-2DAL-D modules on 8.3.0 software version.

    Mario

Similar Threads

  1. WCI Raise or Lower Scene with a Hold
    By Armando B. in forum Programming - HWQS
    Replies: 10
    Last Post: 02-10-2022, 04:52 PM
  2. RGB Raise Lower
    By taylorjacobs in forum Programming - HWQS
    Replies: 0
    Last Post: 08-17-2016, 12:03 PM
  3. Manual Switch Raise/Lower
    By donkeyface in forum Programming - HWQS
    Replies: 3
    Last Post: 10-19-2015, 07:33 AM
  4. Momentary button like Raise & Lower...
    By whdigital in forum Programming - HWQS
    Replies: 1
    Last Post: 10-20-2014, 02:06 PM
  5. Replies: 3
    Last Post: 09-25-2014, 07:14 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •