Hi, I changed a couple lighting fixtures in my house, from non dimmed to an incandescent Dimmed ones, and I wanted to upgrade my system to dim those new lights.. but when I tried to transfer the changes I just got stucked and stopped with the transfer step (processing files) and the wizard just kept trying to stopped there trying to CLEANMEM, FFFFF, and after 3 tries the transfer ends there. the problem is that I read on another post that sometimes you can help unstucking the system, with a manual CLEANMEM (on boot mode) from the terminal itself.. so now 2 bad situations for me: no more transfer, and my 80% lights of the house can't be controlled as they are on a centralized way. my processor leds troubleshooting looks good to me, and I have my Processor with the last revision, and I am using the latest illumination software. the previous change on my system was on June 2016 with no problem at all (same windows that I have today W10).
I've been using the system from 2007, with no problem at all. any help here? thanks in advance for your time and support!
system info:
h4 series, with HRL
Processor 01 O/S Rev : 01.64.00 T5
pinfo: P00164002B050000000F08T
bootrev: Processor 01 Boot Rev : 43
status command: ---------------------------------------
Processor address : 01
Device type : 5
Build Date
The time is NOT set
The date is NOT set
Boot flash : PGM GOOD
Boot rev : 43
OS flash : PGM GOOD
OS rev : 01.64.00
HHP OS flash : ERASED
HHP OS rev : 0
HHP BOOT flash : ERASED
HHP BOOT rev : 0
User baud rate : 115K, 115K
Link 3 is LOGGED IN, Link 7 is LOGGED IN
A power cycle will start : the BOOT BLOCK
The boot mode was : forced via switch S1
>