So here's the situation. My co-worker made some stuff for a client of ours, and I can't seem to figure this out with my common sense and logic; hence why I'm here..
There's two closets:
His Closet
Her Closet
There's two occupancy devices:
Her Closet Occupancy
His Closet Occupancy
There's also two light switches:
Her Closet
His Closet
When I go to one occupancy sensor in the program, it for some reason has both programmed occupancy sensors at the bottom. The problem the client is having, is that when they set off His Closet occupancy, it also turns her light on and vise versa. So I need to make sure one occupancy sensor is strictly for that closet.
Here's the programming:
Any idea how to go about this?