-
hi-lume question, L3D0-96W24V-U...configuring in QS Designer 8.5.0
just finished installing 15' of Lumaris Linear LED Lighting (as an aside, sharp looking fixture!); since that is 75W of lighting (15w * 5w/foot), we purchased a Hi-lume Premier Driver, L3D0-96W24V-U and was planning on controlling that with a HQRD-F6AN-DV. I dropped the HQRD-F6AN-DV into my design and when I pulled down the "interface" entry, the hi-lume driver was not listed, so:
- do I need to upgrade Designer to pick up the new hi-lume driver? if so, what version is required?
- do I care if the "interface" entry is "blank" or does it need to be filled in with "something"?
thanks
-
Load Type
LED Hi-Lume A-Series 3-Wire
Should be nothing in Interface
Not sure what version Software you need I thought that it would be in 8.5 If that 3 wire dimmer is there. With that I would defiantly go to Ver 9.4
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
-
yup...load type was as you described....thanks