Results 1 to 3 of 3

Thread: Power Loss or Processor File Upload?

  1. #1

    Power Loss or Processor File Upload?

    In Illumination we were able to do certain things after a file transfer and maybe even after a power cycle or reboot, memory is a little foggy but I can't seem to find anything in QS 9.4 that allows anything similar. Even if I could set a var based on power or a file that would be nice. I could use a relay and a CCI to trigger a var but that might require a delay. I just want to be able to ensure certain items are on after a transfer or power outage and I'm not finding a way to do this in QS and it was possible (I think) in Illumination and maybe even Interactive.
    VAV
    Danbury, CT

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    375
    I feel your pain I heavily relied on setting variables post upload in illumination and also the ease of load shedding. So far nothing in qs for that. I am able to overcome power failures based on CCO from Transfer switch but the post upload STINKS need that back

  3. #3
    Quote Originally Posted by mcignarella View Post
    I feel your pain I heavily relied on setting variables post upload in illumination and also the ease of load shedding. So far nothing in qs for that. I am able to overcome power failures based on CCO from Transfer switch but the post upload STINKS need that back
    Ok, at least I don't have to feel dumb about not finding it. I'm sure if it really matter that much I could figure a way, maybe using AMX to pole a files last revision date/time stamp or something. I also don't like the QS software either, IMHO Illumination is more logical and easier to navigate after a long period between use. Oh well, such is progress!
    VAV
    Danbury, CT

Similar Threads

  1. devices not working after an upload...sometimes...
    By jkvossen in forum Troubleshooting - HWQS
    Replies: 5
    Last Post: 06-28-2016, 01:43 PM
  2. Sending File Persistent Objects Error During File Transfer
    By 39CentStamp in forum General Discussion - HWQS
    Replies: 1
    Last Post: 02-18-2016, 05:40 PM
  3. Two Processor in One System but one processor failure
    By Syncon in forum General Discussion - HWQS
    Replies: 3
    Last Post: 08-01-2015, 10:08 AM
  4. 4 series processor XML file help
    By dsheppard in forum Troubleshooting - Legacy HW
    Replies: 1
    Last Post: 06-11-2015, 02:45 PM
  5. Can you determine current file name that is loaded to processor
    By scottedge in forum General Discussion - HWQS
    Replies: 5
    Last Post: 04-22-2015, 07:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •