Thanks Thanks:  1
Likes Likes:  0
Results 1 to 2 of 2

Thread: Installing Caseta Wireless in (a) switch location for 3 circuits and (b) slaves

  1. #1
    Junior Member
    Join Date
    Oct 2016
    Posts
    2

    Installing Caseta Wireless in (a) switch location for 3 circuits and (b) slaves

    Hi. I've selected Caseta for compatibility with Apple HomeKit, but my electrician isn't familiar wireless systems nor Caseta. Here's where your insight can help: I've a switch location where I'm planning to have 3 circuits — perimeter for the living room, cans for the living room and dining pendant. And 2 of those were to have slave switch locations elsewhere in the room.

    Do we install THREE caseta switches in the switch location — one for each circuit? And do we install the two slaves elsewhere in the room using traditional wiring? Does Caseta pair with a slave (as Maestro does)? Or is the slave for Caseta just the pico remote control? If yes, do we just place the face plate and the pico remote on the wall to function as a slave (saving $$$ because the electrician is not pulling wires for the slave?)

    thanks!

  2. #2
    Senior Member
    Join Date
    May 2015
    Posts
    307
    Just install the 3 Caseta switches in the switch location, and use the Pico remotes in your "slave" locations, no wiring needed. You can have up to 10 Picos controlling each switch in a stand alone installation.

  3. Thanks Eric H. thanked for this post

Similar Threads

  1. Caseta ON/OFF Switch and normal toggle switch
    By hgmobile in forum Troubleshooting - CAS
    Replies: 3
    Last Post: 05-29-2016, 09:12 AM
  2. Caseta Wireless 600-watt/150-watt Multi-Location In-Wall Dimmer
    By calirap in forum General Discussion - CAS
    Replies: 1
    Last Post: 01-06-2016, 09:19 AM
  3. Caséta Wireless Switch on 220 voltage
    By m11rphy in forum General Discussion - CAS
    Replies: 2
    Last Post: 11-12-2015, 04:17 AM
  4. About Caséta Wireless and Maetro Wireless using outside USA
    By vinhthq in forum General Discussion - Controls
    Replies: 1
    Last Post: 03-09-2015, 02:00 PM
  5. Buzzing noise from the LED Can lights after installing Caseta Dimmers
    By johnbee in forum General Discussion - CAS
    Replies: 1
    Last Post: 10-24-2014, 03:16 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •