Hi
Im working on program using v10.4. system includes but not limited to
4x 2-link processors
112x paladium keypads
40x RPMs
11x MIs
71x roller shades
58x roman shades
I am simply trying to move loads from one area to another. every third or forth load I go to move the program will give the "lutron has stopped responding and needs to close" message.If I hit "wait for program to respond"
after a couple of minutes it will resume as normal, albeit briefly.
As you can understand this gets very frustrating,
laptop running windows 7pro 64bit, i5 2.60ghz processor, 8gb RAM
could it just be the size of the program and my laptop are struggling to get along or is there any underlying issues within the QS?
tia