-
You have to "out of box" the dimmer or switch to remove it completely from the system (triple tap - hold - triple tap). Then put it in pair mode (hold bottom button till Lights flash) and hold the button on the sensor until the two pair (just like pairing a Pico). You can add additional sensors (or Picos) to the standalone dimmer or switch the same way. Hope that helps!
Last edited by Staianoa; 01-07-2017 at 07:25 AM.
Reason: Add more info
-
Post Thanks / Like - 0 Thanks, 1 Likes
-
Add a Powpak
You can just add a powpak after the Caseta switch. Then the switch stays on the system and you can add pico’s, occupancy, and photocells to the system.
Just make sure to add the min load resistor provided with the Caseta switch. The Switch will not recognize the light due to the powpak being between them.
-
Add a Powpak
You can just add a powpak after the Caseta switch. Then the switch stays on the system and you can add pico’s, occupancy, and photocells to the system.
Just make sure to add the min load resistor provided with the Caseta switch. The Switch will not recognize the light due to the powpak being between them.