Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: LED State unknown after initial transfer

  1. #1

    LED State unknown after initial transfer

    After transfer to the system - upon querying the status of an unprogrammed keypad LED via third party - the system reports back 255 (which is undocumented, but appears to mean "unknown"). After setting the LED state, then normal queries result thereafter. Does anyone know if this is expected?

    Also, sending normal flash and rapidflash to the keypad does not result in the keypad actually flashing or rapidflashing - although when viewed in Home+, it looks correct. Does anyone know if this is expected?

    These tests were done using 6.2.0.

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    409
    Since the keypad buttons have no programming on them they will report back a state of 255 after a transfer or power cycle of the main repeater. This is as designed since there is nothing programmed to the buttons. If you add a dummy load to the buttons then after a transfer or a power cycle you will receive the proper feedback for the status LED.

    The RadioRA2 keypads do not support the flash option for the status LED's, this is a HomeWorks QS feature.

Similar Threads

  1. Transfer is take too long to finish
    By stevi in forum Troubleshooting - HWQS
    Replies: 12
    Last Post: 01-17-2014, 09:45 PM
  2. Transfer errors
    By Craig W. in forum Troubleshooting - RA2
    Replies: 3
    Last Post: 12-20-2013, 12:44 AM
  3. Failure to enter activation or transfer
    By Craig W. in forum Troubleshooting - RA2
    Replies: 3
    Last Post: 09-23-2013, 04:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •