Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: *** need help with conditional ***

  1. #1
    Junior Member
    Join Date
    Nov 2014
    Posts
    13

    *** need help with conditional ***

    I am winding down to the end of a job, and we used QSE IO's for dampers for the bathroom exhausts, as well as triggering a fan on the roof. I am having hard time getting it to work properly even though HWSUPPORT has stated they've tested it themselves.

    Basically there are 5 contact closures for the dampers, and 1 contact closure for the fan. As it's written right now. On a button press it will open the damper but not turn on the fan, on the second button press it will close the damper and turn on the fan. Any help would be appreciated.

    Attached Thumbnails Attached Thumbnails HW.jpg  

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    433
    Would Help for me to have file however at first glance I would think you have the 2nd condition within the first condition Did you try taking the 2nd If statement and bring it outside the 1st if statement So basically it looks at the first if and says check damper if its open it close it if it is not open then open it and turn fan on The next checks to see if any dampers are open and if not it will shut the fan off I really think that 2nd if should start under the end if of the first condition.

Similar Threads

  1. Problem with conditional off button
    By keyesguy in forum Programming - Legacy HW
    Replies: 1
    Last Post: 03-21-2016, 11:43 AM
  2. Conditional Logic
    By skalman in forum General Discussion - HWQS
    Replies: 0
    Last Post: 08-27-2015, 02:54 AM
  3. LHC+ 6.0 has lost conditional ''feedback''
    By digit1 in forum Troubleshooting - Legacy HW
    Replies: 4
    Last Post: 04-22-2014, 07:48 PM
  4. Conditional Logic question about If then and Else
    By abutchart in forum Programming - HWQS
    Replies: 2
    Last Post: 12-20-2013, 04:50 AM
  5. HW Illuminations conditional R/S/L/S
    By Craig W. in forum Programming - Legacy HW
    Replies: 3
    Last Post: 05-08-2013, 09:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •