Results 1 to 2 of 2

Thread: Transfer a programme to 100% takes hours of time in 10.3

  1. #1
    Junior Member
    Join Date
    Dec 2014
    Posts
    16

    Transfer a programme to 100% takes hours of time in 10.3

    Hii,

    After pressing "Start Transfer" , 99% completes in as usual time but from 99 to 100% takes hours of time in version 10.3..
    For lower versions it completes as usual time
    .


  2. #2
    Super Moderator
    Join Date
    May 2013
    Posts
    264
    Hello swingajay,
    Thank you for your post.
    If you could generate a support file from this system and send it to hwsupport@lutron.com, we can further investigate this problem.

Similar Threads

  1. Quantum 1.5 to 2.7: Q-Admin – Changing After-Hours Settings
    By Rob L. in forum Programming - Quantum
    Replies: 0
    Last Post: 01-28-2016, 03:03 PM
  2. RadioRA2 Transfer Time
    By TurnipTruck in forum Programming - RA2
    Replies: 8
    Last Post: 11-18-2015, 09:30 AM
  3. 6 of 6 Activated, but 4 of 6 won't transfer
    By JPsarianos in forum Troubleshooting - RA2
    Replies: 13
    Last Post: 12-13-2014, 01:48 AM
  4. Load turning on randomly at all hours
    By totalcontrol in forum General Discussion - RA2
    Replies: 1
    Last Post: 10-07-2014, 01:49 PM
  5. Transfer errors
    By Craig W. in forum Troubleshooting - RA2
    Replies: 3
    Last Post: 12-19-2013, 11:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •