Results 1 to 5 of 5

Thread: Rollback and Time Clocks

  1. #1
    Senior Member
    Join Date
    Jun 2013
    Posts
    666

    Rollback and Time Clocks

    Will the rollback feature pick up a timeclock event as a button/dimmer press? I have a possible model home project that this would be counter-productive if the rollback would see the TC event and start a countdown, thus shutting off lights I would want to keep on. I did see that rollback can be used to turn lights on and that might be a solution, but much more difficult than rollback for normal operation and TC events for after-hours.
    Residential Lighting and Shading Specialist for CED Escondido

    mbalay@cedescondido.com

  2. #2
    Senior Member
    Join Date
    Jun 2013
    Posts
    666
    Was able to discuss this with Tech- The rollback will see the timeclock as a button push and then rollback, effectively turning the TC event "off". If you need both in the same area, you'll have to get creative.
    Residential Lighting and Shading Specialist for CED Escondido

    mbalay@cedescondido.com

  3. #3
    Where is rollback feature hiding in HWQS 10.0?

  4. #4
    Senior Member
    Join Date
    Jun 2013
    Posts
    666
    I don't program HWQS. I believe you need to make a conditional and have a timer associated with the button press/hold/double tap, etc.
    Residential Lighting and Shading Specialist for CED Escondido

    mbalay@cedescondido.com

  5. #5
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    212
    To enable the Rollback feature in HWQS you will need to go to the Programming tab and then use the drop down and select Occupancy. Then in the bottom left corner check the box that says "Show Areas without sensors". Once this is checked you will then have the option to enable rollback for the different rooms in your project.

  6. Thanks SDR-Mike thanked for this post

Similar Threads

  1. Rollback and occupancy sensors?
    By wkearney99 in forum Best Practices - RA2
    Replies: 5
    Last Post: 06-21-2017, 04:25 PM
  2. HQS and RR2 software open at the same time?
    By randyc in forum General Discussion - RA2
    Replies: 2
    Last Post: 09-14-2015, 09:43 AM
  3. Cycle Dim Hold time
    By totesthouse in forum Programming - HWQS
    Replies: 1
    Last Post: 06-19-2015, 09:48 AM
  4. Pollodiom time frame ?
    By mehuneau in forum General Discussion - HWQS
    Replies: 6
    Last Post: 05-14-2015, 04:18 PM
  5. Auto Rollback in QS similar to Illumination?
    By TomTremble in forum Programming - HWQS
    Replies: 3
    Last Post: 01-09-2014, 04:25 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •