Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Vacation mode programing and QS Training Modules

  1. #1
    Junior Member
    Join Date
    Apr 2014

    Vacation mode programing and QS Training Modules

    Am I not looking in the right place or is there a dearth of information for utilizing Lutron Designer to its full capacity? I'm currently scratching my head over programming Vacation Mode. Not looking for hand holding just to be pointed in the right direction.

  2. #2
    Senior Member
    Join Date
    May 2013
    Hello kcraft,
    The vacation mode option is located on the program screen. Then under the drop down select vacation mode. You will need to specify the times vacation mode will run and the lighting loads it will affect. Then the software will generate an occurrence of events for the loads to turn off/on during the time frame specified. This can be seen in the "Summart of Vacation Events". For more information on where to find training materials for the software please contact your local rep.

Similar Threads

  1. Vacation Mode
    By Connected in forum Programming - RA2
    Replies: 5
    Last Post: 11-14-2018, 06:38 PM
  2. Vacation Mode Programming
    By Munday in forum General Discussion - Legacy HW
    Replies: 1
    Last Post: 09-18-2015, 06:15 AM
  3. L2 Training
    By texas doc in forum General Discussion - RA2
    Replies: 3
    Last Post: 05-04-2015, 08:58 AM
  4. Programing Keypad buttons on VCRX
    By DouglasDSmith in forum Programming - RA2
    Replies: 1
    Last Post: 03-18-2015, 08:33 PM
  5. Vacation Mode?
    By thefish in forum Programming - HWQS
    Replies: 6
    Last Post: 12-31-2013, 09:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts