Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Unable to enable RRD-H6BRL-WH backlighting

  1. #1
    Senior Member
    Join Date
    May 2016
    Posts
    198

    Unable to enable RRD-H6BRL-WH backlighting

    I'm having trouble turning on keypad backlighting w/10.1. I set the values to Low in Design, have performed a Transfer, but the light doesn't come on.

    I've been successfully with this previously, using 9.x versions of the RadioRA 2 programming software.

    Any help?

  2. #2
    Senior Member
    Join Date
    May 2016
    Posts
    198
    Just following-up on this. It seems eventually the backlighting eventually becomes enabled. I'm not sure why it wasn't working for the first couple of times I enabled it and did the transfer. Perhaps this settings requires something else to drag it into being a candidate for updating the main repeater.

  3. #3
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    289
    MisterC, this could have been caused by the keypad having transfer issues, did the back light start working after a recent transfer?

  4. #4
    Senior Member
    Join Date
    May 2016
    Posts
    198
    No, there were no transfer issues. Everything reported as OK. The backlight started working after later update; I'd make some other naming changes to buttons, and a couple of other programming changes. My theory was that the backlighting change by itself didn't trigger the software to do an update, but that some other change pulled in the setting and so it started working.

    I had set the backlighting from three keypads, and none of them worked the first couple of times I tried the transfer. And a few days later, after other programming changes I noticed they were working.

Similar Threads

  1. One button out on H6BRL
    By Corey in forum Troubleshooting - RA2
    Replies: 0
    Last Post: 01-22-2016, 01:42 AM
  2. Bathroom Fan and Hybrid H6BRL
    By ntwkdsnr in forum General Discussion - RA2
    Replies: 1
    Last Post: 07-17-2015, 01:21 PM
  3. Timeclock w/ Sensor enable
    By paulhanks in forum Programming - RA2
    Replies: 6
    Last Post: 10-13-2014, 10:04 PM
  4. Can't find how to enable remote access
    By ChrisK in forum Troubleshooting - RA2
    Replies: 7
    Last Post: 11-26-2013, 11:34 AM
  5. Automation of keypad backlighting
    By LightBrigade in forum Programming - HWQS
    Replies: 2
    Last Post: 11-02-2013, 02:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •