Thanks Thanks:  0
Likes Likes:  0
Results 1 to 7 of 7

Thread: Set Plug In Dimming Module to Switching Mode?

  1. #1

    Set Plug In Dimming Module to Switching Mode?

    Hi folks,

    While browsing the documentation of the dimming module:
    http://www.lutron.com/TechnicalDocum...es_English.pdf

    There are several mentions of setting the dimming module to switching mode for loads that don't support dimming. How does one do that? I glossed over the doc and didn't see any info on that. Thanks!

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    289
    Here is the link to the Advanced Programming Guide, this will guide you through setting the plug in dimmer as a switch only.

    http://www.lutron.com/TechnicalDocum...ary/048247.pdf

  3. #3
    Thanks Mike! I don't see the Dimming Module / Switching module in that document, just in-wall switches...?

  4. #4
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    289
    What is the model of the module you have, it should fall under the dimmer section. You would just need to use the Secondary Programming menu on Page 3.

  5. #5
    Actually, I was referring to the RR-3PD-1 (spec sheet in my first post) :)

    http://www.lutron.com/TechnicalDocum...es_English.pdf

    On the bottom of Page 2 of the spec sheet (RR-3PD-1 column) it says "Control non-dimmable lighting loads in switching mode"...

  6. #6
    There is an option in Essentials under the design tab, select load type. There are 8 choices, some are dim-able and others non-dim-able.

    Eric

  7. #7
    So I can just choose the non-dimmable option in the programming software even though the RR-3PD-1 is dimmable?

Similar Threads

  1. Mounting of DIN Rail Dimming/Switching Modules
    By oldguy in forum General Discussion - HWQS
    Replies: 1
    Last Post: 05-24-2016, 11:49 AM
  2. plug in lamp module used as an on/off switch
    By LightingUup in forum General Discussion - CAS
    Replies: 1
    Last Post: 01-28-2015, 09:07 AM
  3. Replies: 1
    Last Post: 12-10-2014, 11:28 AM
  4. Define an Output on a Dimming Module as On/Off Only?
    By David Haddad in forum Programming - HWQS
    Replies: 2
    Last Post: 11-07-2013, 10:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •