Lutron HWQS Programming for Control4 Integration

[rameshkhiani]

I have connected Lutron System with Control4 System over Ethernet by having them on the same network.
Can any one guide me how to integrate them with each other? I have done the following:

On Control4 Side:
- Installed HomeWorks QS Processor driver in Composer 2.8;
- Configured The Lutron processor driver by Giving Network User name & Network Password and IP address to the Processor.

On Lutron HomeWorks QS side I have done the following:
- Connected Lutron processor via Ethernet to the Control4 system.
- Assigned the same IP address as above to the Lutron Processor.

After that I can see the Lutron processor online in the Composer Software.

Now where should I enter that User name and password in Lutron end to communicate with the Control4 System?
Do I go to "Tools->Configure Integration" and set that username and password in Telnet login for the Control4 system to log in. Or there is any other location for that.

What are the necessary requirements that we need to do in our programming at Lutron side?
And How do we configure the Dimming / Switching Modules on Control4 end as we don't have any driver for those Modules in Control4 Composer.
I have already activated those modules in my HomeWorks QS 9.0.0 Software.

Please Advice.

[Blair S.]

Hello rameshkhiani,
You are correct. Under Tools>Configure Integration is where you set the telnet username/password that Control4 will use to sign in.
There is a C4I file for the dimmers and switches. The complete Control4 drivers download can be found at the link.
https://www.houselogix.com/shop/homeworks-qs

[domino]

Also make sure you have the most current set of C4 drivers before building the project in Composer this will ensure all features are available and there are no compatibility issues.

[vbibin06]

Do you have a control4 driver for QSE-CI-WCI ?

[Blair S.]

Hello vbibin06,
Please see this post - https://forums.lutron.com/showthread...ol4-QS-drivers