Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Occupancy Sensor doesn't work after upgrade to 10.0

  1. #1
    Junior Member
    Join Date
    Oct 2013
    Posts
    22

    Occupancy Sensor doesn't work after upgrade to 10.0

    I have an occupancy sensor that doesn't control my lights anymore after upgrade to 10.0 - looks fine in programming - any suggestions? Thanks,Dan

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    289
    Dan: I would recommend calling our Technical Support line so that one of our Radio Ra2 agents can assist you in troubleshooting the occupancy sensor.

  3. #3
    Senior Member
    Join Date
    Oct 2013
    Posts
    518
    One thought, make an SSH terminal connection to the repeater and see if you see messages scroll by when the sensor trips.

    Fwiw, I had to power cycle my repeaters when trying to make the upgrade from 9.3 to 10. Don't do it while there's anything active (like a transfer). I pulled power, counted to 10 and powered them back up again. I have no reason to think that has anything to do with why your sensors might not be tripping, but doing so allows the repeater to reload it's settings, that might help.

Similar Threads

  1. Maestro occupancy dimmer doesn't turn off LED bulb.
    By Bracket in forum Troubleshooting - Controls
    Replies: 24
    Last Post: 11-30-2017, 11:58 AM
  2. Occupancy Sensor
    By texas doc in forum General Discussion - RA2
    Replies: 4
    Last Post: 05-18-2015, 09:16 PM
  3. Crestron RadioRa2 Keypad Monitor feedback doesn't work
    By EricW in forum 3rd-party Integration - RA2
    Replies: 3
    Last Post: 01-30-2015, 05:54 PM
  4. VPN access - Doesn't work !?
    By mehuneau in forum General Discussion - HWQS
    Replies: 1
    Last Post: 12-23-2014, 05:36 PM
  5. MACL dimmer doesn't work
    By Josh B. in forum General Discussion - Controls
    Replies: 2
    Last Post: 05-10-2013, 02:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •