Homeseer home automation have now a 3rd-party integration for RA2

[donmor]

Just create a Plug-in for RA2 that integrate with Homeseer.

[donmor]

By one click it create all your device, after you can control, create events to control RA2, security, zwave, send email, and more.

-Config page for IP, Port and creation of the device
-Creation device by one click
-Control light and appliance
-Simulate the PICO_KEYPAD
-Control SeeTouch_Keypad
-Grafik Eye
-Shade up and down
-Venitian blinds Up/Dpwn/Tilt
-Control Output
-Status of the Led of the SEETOUCH_KEYPAD
-Control Scene of LutronRa2
-Occupancy now working (will stay in motion until your program timer of the device finish)
-Remote 4 GROUP_REMOTE
-RRD-2ANF fan control
-Timeclock ( Away, Normal, Etc you create)
-Run the timeclock event you create in RadioRa2
-Control Thermostat
-Config page with Option to not change graphics or name of the device to the default of RadioRA2

[sizelove]

Very specific question...
With Homeseer and the plugin to both Caseta and RR2, could I program everything so that I can push a button on the SEETOUCH_KEYPAD and it operate both RR2 and Caseta at the same time? Or, can I push a button the SEETOUCH_KEYPAD and it control Caseta devices?

[donmor]

Very specific question...
With Homeseer and the plugin to both Caseta and RR2, could I program everything so that I can push a button on the SEETOUCH_KEYPAD and it operate both RR2 and Caseta at the same time? Or, can I push a button the SEETOUCH_KEYPAD and it control Caseta devices?

Yes but you need both plugin, to control caseta only with the seetouch just give the button a name without assign a device than in HS make an events when the seetouch button is press do what you want with the Caseta, to control both 2 choices, let seetouch control the RA2 device and in homeseer make the events to control Caseta or make homeseer to control both. You can do the same thing with a pico or any device of Caseta and RA2.

[Zach R.]

Very specific question...
With Homeseer and the plugin to both Caseta and RR2, could I program everything so that I can push a button on the SEETOUCH_KEYPAD and it operate both RR2 and Caseta at the same time? Or, can I push a button the SEETOUCH_KEYPAD and it control Caseta devices?

This will work, but you will probably notice a slightly delayed response from the Caseta devices. This may be even more noticeable because the Radio RA2 devices will appear to respond instantly (via Clear Connect RF rather than HomeKit).

I have been using a 4-Button Pico (and a Caseta plug in dimmer) to control 3rd party HomeKit devices...the Caseta devices respond instantly via RF, while the 3rd party devices have a slight delay when responding to the HomeKit "trigger".

[donmor]

I don't know about the HomeKit but with homeseer it it's hard to see the deference. See this post from a user: http://forums.homeseer.com/showthread.php?t=186984