Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: Setting shades to a specific level?

  1. #1

    Setting shades to a specific level?

    HWQS with QS wired shades project.

    I thought for sure there was a way to send a shade to a specific shade level.

    I've done this a hundred times in Illumination with QED shades.

    In QS, all I see is "send to preset 1/2/3/4" That really wont work for any of our programming models. Am I missing something here? Thanks in advance.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    433
    Under program tab choose shade presets then choose the shade you want to edit the presets for.Then click on the preset edit name the preset to the level you set it too . Then just assign that preset to the button you want to drive it You can make the presets any level you want. I just name the preset to the shade level for conveince

  3. #3
    OK, thanks.
    Sure would be simpler if you just could out 50% in the level line, like a dimmed load.

Similar Threads

  1. dimmer not going back to last level
    By Craig W. in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 05-16-2013, 03:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •