-
Software request-Update Touchpros
We just had a job where we had a bunch of touchpros to install. In the QS software, you can set the touchpro up to your heating system. Single Zone Hydronic Heat only in our case.
But when you go to address, those settings don't transfer. It would be nice if they did. That way we know the tstst and software are all on the same page, so to speak.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
-
Authorized Lutron Contributor
Thank you for this feedback. We will relay this information to our development engineers for consideration on a new iteration of the TouchPro.