Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Lights flash once, don't come on

  1. #1

    Lights flash once, don't come on

    I'm pretty new here with lutron. One of the switches I installed was a PD-5WS-DV-WH. In a dual T8 fixture I bypassed the ballast, tried these and these. The first set are worse, but both bulbs will flash once and not come on. If I turn it off and on (sometimes repeatedly) they will come on and stay on. The provided MLC was installed (without it the switch blinks red). After searching the forums I didn't come up with much, I followed some links to bulb choosers, but they just confused me further. Any guidance would be appreciated. Thanks!

  2. #2
    Lutron Technical Support
    Join Date
    May 2013
    Posts
    635
    We have seen some instances where the PD-5WS-DV isn't able to switch some LED loads, even with the LUT-MLC installed. In these cases we would recommend using the PD-6ANS-color (neutral required) Caseta switch instead of the 5WS-DV.

Similar Threads

  1. Lights flash when turned on
    By Grsthegreat in forum Troubleshooting - CAS
    Replies: 47
    Last Post: 04-19-2022, 12:11 AM
  2. Security flash/full on vcrx
    By Tom L in forum General Discussion - RA2
    Replies: 14
    Last Post: 09-26-2016, 11:23 AM
  3. Fan Button with Keypad LED Flash rate
    By awang in forum Programming - Legacy HW
    Replies: 0
    Last Post: 11-04-2015, 03:21 PM
  4. Bug? - Flash Output Causes whole system to flash
    By rdgerken in forum Troubleshooting - RA2
    Replies: 3
    Last Post: 12-16-2013, 07:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •