Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Insufficient Dimming

  1. #1

    Insufficient Dimming

    LECL-150H

    Unable to set desired low level dim. Used blue side control potentiometer lever and moved fully minus. Unit has a mechanical stop on both the plus and minus settings that appeared to limit full rotary travel of the pot wiper.

    Cut drive stub from side lever to pot and removed actuator shaft. Turning pot manually indicated that full travel was not mechanically restricted.

    Want to set dimmer at lowest possible setting where flicker occurs, and then raise just above this level (as instructions say).

    Need circuit diagram -- or how to modify unit to accomplish this.

    electrical engineer.

  2. #2
    Lutron Technical Support
    Join Date
    Mar 2022
    Posts
    129
    Hello Himmel. Welcome to the forums. The lowest position that the trim pot can be set to from the factory is the lowest that the control is able to go. We cannot advise modifying the control to attempt to achieve a lower setting than what it is engineered to do.

Similar Threads

  1. RRD-6NA vs RRD-Pro dimming
    By uscpsycho in forum General Discussion - RA2
    Replies: 1
    Last Post: 12-24-2020, 11:25 PM
  2. Replies: 3
    Last Post: 06-18-2020, 10:59 PM
  3. 0-10v Dimming
    By heimdm in forum General Discussion - RA2
    Replies: 6
    Last Post: 01-30-2018, 10:51 AM
  4. 0-10 dimming
    By davidwho in forum Design Assistance - RA2
    Replies: 0
    Last Post: 06-23-2017, 10:21 AM
  5. Dimming a <25W LED?
    By cliqk_h in forum General Discussion - CAS
    Replies: 1
    Last Post: 03-30-2016, 08:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •