I am having a problem with a Caseta in wall light dimmer. The switch has two Utilitech MQTL1017-LED11.5K850 LEDs (listed as compatible by Lutron when at least two bulbs are connected). When I turn the switch on, both of the LEDs flash about every 1.5 seconds. Adjusting the trim levels up or down does not help. I swapped the switch out with a new Caseta switch but the problem persisted. The old conventional switch works fine.
Would the Caseta on/off in-wall switch (which is interestingly more expensive than the dimming switch) work in this setup? Dimming is not essential for these particular bulbs.