Hi
I am setting up a system and have a Hybrid repeater conected to L2 but I was having trouble activating it. Almost certainly as it was used previously for some bench testing. No problem as a facory default should sort this but whenever I follow the factory reset procedure it does not follow what I am expecting and I'm a bit stuck on what should be a simple task.
I press the test button three time quickly (I have tried four as the instructions say at least 3). On the 3rd press I hold the test button and all the LED's begin to flash (say 0.5 interval). The instructions say to wait for the LED's to flash slower (about three seconds), then release the Test button and confirm immediately with another three presses. It implies I should get a reset bleep but I don't and I don't think the factory default has worked so the process of holding the activation button for 6 seconds and activating the unit never works.
Normally i don't have an issue on a factory reset but I have never done a Hybrid repeater before.
Thanks