Hi,
I will try to be brief.
New to RA2. Using 12.10.0 Inclusive software.
Test 1
Two Main Repeaters with most recent firmware
One Dimmer on MR 1
Two Picos on MR 1
Both Picos configured to control Dimmer.
Activation went fine
Transfer went fine
Testing went fine
Test 2
Two Main Repeaters as before
One Dimmer on MR1 as before
One Pico on MR1 as before
One Pico on MR2 (moved from MR1)
Both Picos configured to control Dimmer as before
Channel change of Pico on MR2 went fine
Activation went fine
Transfer went fine
Testing did NOT go fine:
- The Pico on MR1 worked as before
- The Pico on MR2 no longer controlled the Dimmer on MR1
- The RF light on MR2 flickered in response to pressing buttons on the Pico on MR2
Created Telnet logins on both MRs
Telnetted into to both MRs.
Could see Telnet output on both MRs matching button presses of Pico on MR1 AND Pico on MR2
Could send commands via Telnet on either MR and Dimmer behaved correctly
Could not get Dimmer on MR1 to respond to Pico on MR2
Any ideas what I did wrong?
Thanks, Frederick