Maestro MACL-153M-WH-C Not working upon install

[kds1980]

Hello,

I have track lighting that has 8 LED bulbs. (Sylvania LED16PAR38/DIM/830/FL40 - 16W). I currently use DIVA DVCL-153P, but wanted more control over the lighting so purchased MACL-153M-WH-C. I wired it in exactly the same (single pole) and it will not operate the lighting. It shows IL1 illuminated so I know there is power, but won't do anything else. If I remove and reinstall the DIVA unit, it works perfectly. As far as I can tell, they have the same compatibility specs. Please advise, since I can't find any literature indicating what IL1 being illuminated means.

[randyc]

Make sure you have power in connected to the black screw on the Maestro. The wire going to the light should be connected to the brass screw. The blue screw is not used in single pole applications.

[kds1980]

Make sure you have power in connected to the black screw on the Maestro. The wire going to the light should be connected to the brass screw. The blue screw is not used in single pole applications.

Hey Randy,

The switch is wired as you described. The indicator light IL1 is also lit, so I can see that the unit is powered.

[randyc]

You may be stuck in manual programming mode. You can rest to factory defaults as follows

Pull the FASS out and wait 5 seconds.
Press and hold the tap button then push the FASS in. Continue to hold the tap button for 15 seconds. The load light should turn off then back on to 100%.

The dimmer will enter program mode (IL1 will turn on). Don't stop the reset - continue to hold.