Lutron-Lutron Integration: QS <--> QSX Comms?

[martopg]

Hi all,

I've done a bit of searching on this and couldn't come up with much. We've run into a few cases where we are looking to upgrade systems from QS to QSX but can't do the whole systems at once due to size/scope/schedule/etc.

What would be convenient in this case is to have a way for a QS system to integrate with a QSX system (i.e. send commands to the QSX system). I know QSX only supports LEAP officially, but is there anything special for QS that would allow this?

Use cases are things like global (estate-wide) scenes.

For the reverse: I know the QSX system can send telnet commands to the QS system. Is this the cleanest way of doing the integration between the two?
And while this is possible, this is less useful for our use cases where we'll likely start with a small QSX presence.

[johnmax]

Easiest way unfortunately to do this is to have a control system inthe middle like Crestron so you can router things back and forth between the two systems.