Occupancy Sensor Issues

[MHarr]

Remote battery powered LRF2-OCRB-P x 2 mounted on ceilings in each stairwell, commercial building. Batteries all tested good. Typical switch location gang boxes have cover plates and are spliced straight through. Can't find any other controls in gang boxes or behind fixtures. What other components could those sensors be communicating with? They also stay on and have to be turned off manually with the push button located on the motion sensor body.

[MHarr]

Got ahold of tech support by phone. They suggest RMJS-5R-DV-B as a possible 5A load control or the 16A model. Seeing as they're small I'll have to do some poking around to find them. They also suggested that either the sensors or the PowPack were equally likely to be at fault and troubleshooting would be required once the load controls were located.

https://www.amazon.ca/Lutron-LRF2-OC...IU4/ref=sr_1_1
https://www.amazon.ca/Lutron-RMJS-5R.../dp/B07D8ZPM58

[Sef1979]

Lights turning on and of every few seconds. Issue comes and goes. Any suggestions?

[Kenneth P.]

Hello Sef1979, thank you for reaching out. To best help, what devices are controlling your lights? Specifically, what model of hard-wired controls (either powpak, panel, or in-wall control) as well as any additional controls (such as picos, sensors, etc.)?

The best suggestion would be to start troubleshooting at the hardwired controller by itself (set to default to unpair any devices) and make sure that's working without any sort of backfeed issues. Then one-by-one pairing your devices and test the installation until you find the culprit.